QNAP VS-8124U-RP PRO+ User Manual download pdf (Page 236)

236

outgoing packets between the Ethernet

interfaces, using the same one for each

specific destination when possible. It

transmits based on the selected transmit

hash policy. The default policy is a simple

slave count operating on Layer 2 where the

source MAC address is coupled with

destination MAC address. Alternate transmit

policies may be selected via the

xmit_hash_policy option. Balance XOR mode

provides load balancing and fault tolerance.

trunking. Make sure

static trunking is

enabled on the

switch.

Broadcast

Broadcast sends traffic on both network

interfaces. This mode provides fault

tolerance.

Supports static

trunking. Make sure

static trunking is

enabled on the

switch.

IEEE 802.3ad

(Dynamic Link

Aggregation)

Dynamic Link Aggregation uses a complex

algorithm to aggregate adapters by speed

and duplex settings. It utilizes all slaves in

the active aggregator according to the

802.3ad specification. Dynamic Link

Aggregation mode provides load balancing

and fault tolerance but requires a switch

that supports IEEE 802.3ad with LACP mode

properly configured.

Supports 802.3ad

LACP

Balance-tlb

(Adaptive

Transmit Load

Balancing)

Balance-tlb uses channel bonding that does

not require any special switch. The outgoing

traffic is distributed according to the current

load on each Ethernet interface (computed

relative to the speed). Incoming traffic is

received by the current Ethernet interface. If

the receiving Ethernet interface fails, the

other slave takes over the MAC address of

the failed receiving slave. Balance-tlb mode

provides load balancing and fault tolerance.

General switches

1 2 ... 231 232 233 234 235 236 237 238 239 240 241 ... 351 352

Comments to this Manuals

No comments