221
If the disk volume is configured as RAID 0 or JBOD and one or more of the hard drive
members are disconnected or unplugged, you can plug in the same hard drives into
the same drive slots and use this function to recover the volume status from “Not
active” to “Normal”. The disk volume can be used normally after successful recovery.
Maximum number of disk removal allowed
After recovering a RAID 1, RAID 5 or RAID 6 disk volume from
not active to degraded mode by the RAID recovery, you can read
or write the volume normally. The volume status will be
recovered to normal after synchronization.
If the disconnected drive member is damaged, the RAID
recovery function will not work.
Read Only
Protection
(for
immediate
data backup
& hard drive
N-1, bad blocks found
in the surviving hard
drives of the array.
N-2, bad blocks found
in the surviving hard
drives of the array.
Comments to this Manuals