QNAP VS-8124U-RP PRO+ User Manual download pdf (Page 84)

are supported in Dewarping mode.

Remark 2: If Dewarping mode is Rectangle, you can use PTZ control panel to

operate PTZ functions, excluding digital zoom.

4. Applied to specific camera models with panomorph lens

Before using this feature, you need to select the ‘Enable panomorph support’

option in the camera configuration page. After enabling the feature, you can

select Mount type, including wall, ceiling, and floor and then select Dewarping

mode, including Perimeter mode, Quad mode, and PTZ mode.

Remark 1: To know the camera models that can be installed with panomorph

lens, please visit http://www.qnapsecurity.com/faq_detail.asp?faq_id=718.

Remark 2: The function is only available when the resolution of the video

stream is higher than 640x480 on the monitoring page.

Remark 3: If Dewarping mode is PTZ mode, for the channel, you can use PTZ

control panel or mouse (by clicking and holding down the mouse left button,

and then moving the mouse or turning the mouse wheel) to change viewing

angles or zooming in/out the screen. If Dewarping mode is Quad mode, the

above methods can also be applied to operate PTZ functions in each divided

screen.

5. When the digital zoom function is enabled on multiple IP cameras, the zooming

function will be affected if the computer performance is not high enough.

6. Properties

A. Streaming:

I. Use custom settings

i. Always stream from the server: Select this option to stream the

audio and video data from the NVR. If the computer cannot

connect to the IP cameras, select this option to allow the NVR to

stream the data. No extra port forwarding is required; however,

1 2 ... 79 80 81 82 83 84 85 86 87 88 89 ... 351 352

No comments

QNAP VS-8124U-RP PRO+ User Manual Page 84