QNAP VS-8124U-RP PRO+ User Manual download pdf (Page 153)

153

Advanced Mode

The advanced mode consists of the event and action sections. Define the action to

take for each event triggered on the IP cameras or the video servers connected to the

NVR.

To configure the advanced event management by the ‘Advanced Mode’, select an

event type on the left event list and configure the actions to take on the right.

Note:

 Click ‘Apply’ to apply the settings or ‘Exit’ to exit the settings page. If the

‘Advanced Mode’ is selected on the ‘Alarm Settings’ page, the advanced settings

will be applied after the NVR restarts even if you have selected to exit the

settings page. The settings will be cancelled if ‘Traditional Mode’ is selected

after exiting the ‘Advanced Mode’.

 To avoid blocking by the firewall, the IP cameras or the video servers configured

for the alarm recording must be located on the same subnet as the NVR.

 To switch from the advanced mode to the traditional mode, select ‘Traditional

Mode’ and click ‘Apply’.

Events:

The events supported by the NVR are classified as camera events (motion detection,

alarm input, camera disconnection), NVR events (recording failure), and external

events (user-defined events).

Note: The camera events available depend on the features supported by the IP

cameras or video servers.

1 2 ... 148 149 150 151 152 153 154 155 156 157 158 ... 351 352

No comments

QNAP VS-8124U-RP PRO+ User Manual Page 153